See more Wastes, traps & overflows
FloPlast Standard Bottle Trap (Dia)32mm
Part of the drainage system, this standard bottle trap from FloPlast is made from hard-wearing polypropylene and has a compression fitting type. It's suitable for plastic and copper pipes.
- Comes with Full 76mm seal
|Included||Full 76mm seal|
Threads are poor. Strip under hand tightening.
jwhitw - 8 months ago
Unable to tighten enough to seal prior to threads slipping
This is absolute rubbish
Quikydrew - 11 months ago
This does not do anything at all for purpose. It leaks like crazy and its all so massive compared to others what's a waste of money and I easily rectified it by throwing in the bin and going screw fiv which worked perfect first time and is better quality
Useless, leaky rubbish.
Icantremember - 1 year ago
Useless. Seal is thin, doesn't tighten on straight, jumps threads while tightening. Why even stock this product? Mac alpine equivalent bought from the fixer of screws. Worked first time.
DIY Gaz - 1 year ago
Buy a tube of sealant if you are thinking of buying this. I Could not get it to seal between the metal sink waste and bottle, due to the ridiculously small o ring fitted in the product. Really poor design!
so far so good
hankdutch - 1 year ago
I thought UK product should be OK and picked it up then saw the low ratings on reviews. Trepidation inspected the seals and the mating faces, but all seemed OK. The thread on the bottle is slight stiff so I can see how it could be cross-threaded by the careless. It closes with a confirmatory 'click' as the seal seats in the recess, I applied a little soap as the rubber feels quite grippy to stop it from displacing. The top seal is square and was twisted, so I can see how it might leak if not corrected or checked. There was a shard of plastic on it. Again some soap, cleaned the shard, and seated it correctly. The pipe connector has two tiny mould marks on the seal, I kept them to the sides just in case, but would not expect any issues with this.
Tested and fitted no issues.